Cart:

0 $0.00
You have no items in your shopping cart.

0

AVK500 - Axiom Vacuum Hold-Down Kit

$159.00

Quick Overview

Struggling to secure parts on the bed of your new CNC router? You'll be amazed of the holding power of this exciting NEW accessory!

Only 0 left
 
OR

Details

Securing your workpiece to the bed of your CNC router often creates a challenge.  The Axiom vacuum hold-down kit is a terrific accessory which makes securing your part a snap. Use just one pod to secure a small part, or all five pods to hold something large.

These compact Vacuum Pods are made from clear acrylic, each with it’s own vacuum seal. Each pod is connected together to cover a large area. Place the pods on your Axiom CNC table and secure with screws and T-nuts (included). Pods can be mounted either on top of your MDF spoil board or directly to the aluminum table by selecting the appropriate length screws. Cut the 1/4" hose to the desired length and connect the pods and valve to the vacuum port on the venturi. Use the remaining hose and fitting to connect your compressor to the air port on the venturi.

You'll be amazed of the holding power of this exciting NEW accessory!

Included:
• Vacuum Pods (5 pcs)
• On/off valve
• Venturi vacuum pump
• Mounting hardware
• End cap
• Hose (200")
• Air fitting
• Replacement gasket material

Note: requires 1.5CFM of compressed air at 90PSI

Additional shipping charges may apply for any orders shipped outside the lower 48 states. Contact us for quote.

Write Your Own Review

  1 star 2 stars 3 stars 4 stars 5 stars
Rating